Creality CR-10S Pro - Loading Filament; Preheat for Filament Loading; Filament Feeding Process; Replacing Filament During Printing

200
u Feeding
6. Loading Filament
u Preheat
Method 1
Method 2
Press and hold the extruder lever and insert the 1.75mm
filament through the filament detector and through the
extruder motor. Continue feeding until you see filament
extrude from the nozzle.
Replacing Filament During Print:
1、Cut the previous filament near the extruder and slowly
feed new filament though the filament sensor and
extruder, until the new filament is fed into the PTFE tube.
(OR)
2、Preheat the nozzle and withdraw the used filament.
Feed the new filament as pictured above.
6