Method 1、
Method 2、
Press and hold the extruder lever and insert the 1.75mm
filament through the filament detector and through the
extruder motor. Continue feeding until you see filament
extrude from the nozzle.
Replacing Filament During Printing:
1、Cutting the previous filament near the extruder and slowly
feed new filament though the filament sensor and extruder, until
the new filament is fed into the PTFE tube.
(Or)
2、Preheat the nozzle and withdraw the used filament. Feed the
new filament as pictured above.
u Feeding
u Preheat
200
06/
Loading Filament
To Next Page
Loading...
