Creality Ender-3 Max User Manual

6
Cable Connection
设备接线
Connect X, E, Z-axis stepper motors according to the yellow label on the 6-pin (4 wires) port. 按照6-pin（4根线）端口上黄色标签提
示连接X、E、Z轴步进电机。
Connect X, Z-axis limit switches according to the yellow label on the 3-pin (2wires) port. 按照3-pin（2
根线）端口上黄色标签提示连接X、Z轴限位开关。
z
Caution
Do not connect or disconnect the cables
when the machine is powered on.
当机器通电时，请勿连接或断开连接线。
●Select the correct input voltage to match your
local mains
(115/230V)
●Damage can occur if voltage is set incorrectly.
●Connect the power cord and turn the power
switch to position 1.
●选择正确的输入电压以匹配您的本地电源。
（115/230V）
●如果电压设置不正确，可能会造成损坏。
●连接电源线并将电源开关拨至1档即可开机。
5
Power cord
I
电源线 x 1
The flat cable must across from under basic profile and
behind the material rack，otherwise it will cause the
problems of lack of wire length。(as shown in the left
picture).
排线必须从底座型材下方及料架后方穿过，否则会导致线
路长度不足的问题（如左图所示）。
X
X
E
Filament detector
断料检测
X、Z-axis limit switch
X、Z轴限位开关
X、E、Z -axis motor port
X、E、Z轴电机接口

Creality Ender-3 Max Specifications

General

Build Volume	300 x 300 x 340 mm
Layer Resolution	0.1-0.4 mm
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Max Nozzle Temperature	260°C
Max Bed Temperature	100°C
Connectivity	SD card, USB
Technology	FDM (Fused Deposition Modeling)
Machine Dimensions	513 x 563 x 590 mm
Power Supply	350W
Printing Speed	180 mm/s
Supported Materials	PLA, ABS, TPU, PETG
Display	4.3-inch Color Touchscreen