Creality K1C User Manual

6. Tips and Routine Maintenance
01
25
6.2.3 Cleaning of debris inside the chassis
① Together with the flexible platform after the printed
model has been cooled down Remove from the device
and partially bend the platform slightly to separate the
model from the platform.(No excessive bending of the
platform to prevent it from being deformed and unusable)
② The residue of the platform filaments
canbe scraped off with a blade. Be cautious
of safety when using.
③ When the first layer of the model is not
glued, it is recommended to apply glue stick
evenly on the surface of the platform.
Reminder: Since the printing platform is quick-wear, it is recommended to replace the
printing platform regularly to ensure that the first layer of the model is adhered.

Creality K1C Specifications

General

Nozzle Diameter	0.4 mm
Filament Diameter	1.75mm
Build Volume	220*220*250mm
Print Speed	600 mm/s
Max Hot End Temperature	300°C
Supported Filaments	PLA, PETG, TPU, PA, ABS, PC
Connectivity	USB, Wi-Fi
Printing Technology	FDM
Display	4.3-inch Touchscreen
Leveling Mode	Automatic