White Rabbit Switch - WRS
3.4 Login using the Web Managment Interface (WMI)
The easiest way to access and manage the WRS is using the web interface, it is necessary to
connect the WRS manager ethernet port to your local network and obtain the IP as explained
in Obtain the WRS IP. The access should be carried out by a network browser (Mozilla Firefox
and Google Chrome supported) as it follows:
1. First you need to obtain the IP of WRS as explained in Obtain the WRS IP
2. Open your browser and type the IP address (i.e. 192.168.95.101) of the WRS.
3. After accessing the WMI, you should enter the login using root’s password, otherwise
you will be only able to see the Dashboard info. By default there is no password, so you
should leave this field empty. For this reason it is strongly recommended to change the
password.
Changing root password:
In order to change the WMI password you just need to login, then click on “User: root” on
the left side of the webpage.
In the USER ADMINISTRATION panel, you have to enter your old password, the new
password and its confirmation. Once you submit the new password you will be redirected to
the main screen and logged out.
Note: By changing the password through the WMI you will also change the root user
password to connect through SSH.
Creotech Instruments S.A. tel. +48 22 233 10 27
ul. Gen. L. Okulickiego 7/9 e-mail: support@creotech.pl
05-500 Piaseczno, Poland www.creotech.pl
Page 9 of 30
To Next Page
Loading...