White Rabbit Switch - WRS
9 Safety
Warning: Do not block the air vents which are located on back panel of the WRS, the
internal temperature might increase and damage the switch.
Warning: To increase the lifetime of the WRS it is recommended to use the switch in a
controlled ambient environment and limit to the ambient condition stated in the Specification
Appendix.
Warning: The standard power source for this equipment is designed to work in the range
of 220-240V with 50-60Hz.
Warning: This equipment is intended to be grounded using the Grounded Connector.
Ensure that the host is connected to earth ground during normal use.
10 Warranty
The WRS is fully factory tested and warranted against manufacturing defects for a period
of one year. As the circumstances under which this WRS is installed can not be controlled,
failure of the WRS due to installation problems can not be warranted. This includes misuse,
miswiring, overheating, operation under loads beyond the design range of the WRS. For war-
ranty or nonwarranty replacement send the WRS to producer (Address in section: Producer
and technical support center)
Creotech Instruments S.A. tel. +48 22 233 10 27
ul. Gen. L. Okulickiego 7/9 e-mail: support@creotech.pl
05-500 Piaseczno, Poland www.creotech.pl
Page 29 of 30
To Next Page
Loading...
Need help?
General