White Rabbit Switch - WRS
5.2 Login via SSH
The Ethernet management port automatically obtains its IP using the DHCP protocol.
If you do not have any DHCP router/server in your network please refer to the non-DHCP
section.
1. To check the IP of the WRS you can connect to your DHCP server interface and retrieve
the IP, or connect to Managment Mini USB port to retrieve the IP (ipconfig eth0).
2. Then you need to:
(a) mark Connection type: SSH
(b) WRS IP address
(c) click Open
Creotech Instruments S.A. tel. +48 22 233 10 27
ul. Gen. L. Okulickiego 7/9 e-mail: support@creotech.pl
05-500 Piaseczno, Poland www.creotech.pl
Page 14 of 30
To Next Page
Loading...