White Rabbit Switch - WRS
2. By editing the dot-config file in a terminal
If you prefer to configure the WRS using a terminal you should open the dot-config file
v i / e tc / dot−c o n f i g
And replace the following lines:
# CONFIG TIME GM i s not s e t
# CONFIG TIME FM i s not s e t
CONFIG TIME BC=y
by
CONFIG TIME GM=y
# CONFIG TIME FM i s not s e t
# CONFIG TIME BC i s not s et
and finally you need to reboot the switch.
7.5 Firmware update
Since the firmware v4.1 we have improved the update procedure and the switch is able
to upgrade by itself. Just copy the firmware you have donwload to the /update folder in the
switch. For instance you can do:
scp wr−switch−sw−v<X.X−YYYYMMDD> b i n a r i e s . t a r root@192 . 1 6 8 . 1 . 5 0 : /
update /wrs−firmware . t a r
and then reboot the switch
You can also use the Advanced Mode - Firmware menu in the Web Interface to perform
this step.
Creotech Instruments S.A. tel. +48 22 233 10 27
ul. Gen. L. Okulickiego 7/9 e-mail: support@creotech.pl
05-500 Piaseczno, Poland www.creotech.pl
Page 23 of 30
To Next Page
Loading...
Need help?
General