Crestron CHV-THSTAT User Manual

Thermostats Crestron CHV-TSTAT and CHV-THSTAT
Slab 1 – Floor Warming Only (Continued)
OTHER SETTINGS
SETUP: OTHER SETTINGS
NO APPLICABLE SETTINGS
SENSORS
SETUP: SENSORS
Sensor
Internal:
Remote 1:
Remote 2:
>TEMP HUM
OMIT USE
SLAB
DETECTED: 1 x T
NOTE: Built-in temperature sensor signal locked out
in Floor Warming mode for Slab 1 system type.
Choose SLAB (Remote Sensors Only)
NOTE: Remote 1 and Remote 2 options do not
appear on this screen if these sensors are not
connected.
SERVICE/TEST
SETUP: SERVICE/TEST
Slab Heat Call:
Humidifier Call:
Fan Call:
OFF
OFF
OFF
NOTE: This screen bypasses all system delays
and is used by the installer to manually operate
the HVAC system. Only one system can be run
at a time.
Press MODE button to return to the first screen.
Simultaneously press and hold the MODE and
VIEW buttons to return to normal operation
mode.
Press MODE button to return to the first screen
Or
Press and hold the MODE and VIEW buttons
simultaneously for five seconds to exit Setup.
NOTE: You cannot exit if the sensor setup does not meet
system requirements.
36 • Thermostats: CHV-TSTAT and CHV-THSTAT Operations and Installation Guide – DOC. 8163C

Crestron CHV-THSTAT Specifications

General

Brand	Crestron
Model	CHV-THSTAT
Category	Thermostat
Language	English