17
• Subnet Mask: Indicates the subnet mask that is set on the network
• Default Router: Indicates the IP address of the default router
• MAC Address: Indicates the MAC address of the switcher
Default settings consist of the following:
• DHCP is set to ON.
• The System ID of the switcher is set to 1.
• Connection to the Crestron XiO Cloud service is set to Enable.
• DMC-CPU Compatibility Mode and Content LAN Mode are disabled.
• SSL Certificate is set to Off.
Configure Ethernet Setup Settings
If no changes are necessary on the Ethernet Setup page when the web interface is
accessed for the first time, click the Accept Current Settings button.
To change the current settings on the Ethernet Setup page, refer to the following
sections as desired.
NOTE: All changes except control system changes require a system reboot.
Configure Ethernet Settings
Configure Ethernet settings in the Settings section of the Ethernet Setup page:
1. Disable or enable DHCP by clicking OFF or ON, respectively. The default setting
is ON.
2. Enter the hostname of the switcher.
3. Enter the domain name of the switcher.
4. (Applicable only when DHCP is set to OFF) Enter the following:
a. Unique static IP address of the switcher
b. Static subnet mask of the network
c. Unique static IP address of the default router
5. Using the up button ( ) or down button ( ), select a unique system ID
for the switcher. The system ID determines the internal IP address used by each
device in the DigitalMedia™ system. Values range from 1 to 64. The default
setting is 1.
NOTE: When multiple switchers are cascaded, each switcher must have a unique
system ID. It is recommended that a value ranging from 2 to 64 be used.
A system ID other than the default setting of 1 prevents potential conflicts
when bringing additional switchers online.
To Next Page
Loading...
Need help?
General