Crestron DMPS-100 User Manual

DigitalMedia Presentation Systems Crestron DMPS-100/200/300-C/300-C-AEC
42 • DigitalMedia Presentation Systems: DMPS-100/200/300-C/300-C-AEC Operations Guide – DOC. 7219D
Program Output
The Program Output section of the “Audio Setup” menu is used to set the program
output source mix, bass, treble, program delay, minimum volume, maximum
volume, startup volume, and stereo/mono settings.
Access the
“Program Output” Menu
To access the “Program Output” menu:
1. Access the “Audio Setup” menu as described on page 40.
2. Press the k or j buttons until Program Output is displayed on the LCD
and press ENTER to display the “Program Output” menu.
3. To return to the “Audio Setup” menu, press MENU.
Set the Program Source Mix
To set the program source mix:
1. Access the “Program Output” menu as described above.
2. Press the k or j buttons until Source Mix is displayed on the LCD and
press ENTER to display the “Program Source Mix” menu.
“Program Source Mix” Menu
Program Source Mix
Aud. Only
j
3. Press the k or j buttons until the desired setting is displayed on the LCD.
The current setting is indicated with an asterisk (*). The following settings
are available:
• Aud. Only: Sends the audio signal from the selected source to the
PROG OUT connector.
• Mic. Only: sends the microphone input signal to the PROG OUT
connector.
• Mic + Aud: Sends a mix of the audio signal from the selected
source and the microphone input signals to the PROG OUT
connector.
NOTE: While setting the program source mix, the program volume level
can be adjusted by turning the VOLUME control clockwise to raise the
volume, or counterclockwise to lower the volume. When adjusting the
volume, the display changes to indicate the volume level.
4. Press ENTER to save changes and return to the previous screen. To cancel
without saving changes, press MENU.
Set the Program Bass Level
To set the program bass level:
1. Access the “Program Output” menu as described above.
2. Press the k or j buttons until Bass is displayed on the LCD and press
ENTER to display the “Program Bass” menu. The current bass level is
displayed.
“Program Bass” Menu
Program Bass
k
0dB j

Crestron DMPS-100 Specifications

General

Brand	Crestron
Model	DMPS-100
Category	Projector
Language	English