Crestron HD-MD4X2-4K-E - Configuring Output Settings via Web Interface

8
•
HD-MD-6X2/4X2/4X1-4K-E: 4K HDMI Switchers Supplemental Guide – DOC. 7761A
b. In the
Inputs
section of the page, configure each input as follows:
NOTE:
For each input, the Sync icon denotes whether a source is
detected at the input. If a source is detected, the icon is green. If no source
is detected, the icon is gray.
i. In the
Name
text box, rename the input if desired.
ii. If an EDID other than the Global EDID is to be assigned, select the
desired EDID in the
EDID
drop-down list.
iii. In the
HDCP Support
drop-down list, select
Enabled
or
Disabled
.
The default setting is
Enabled
.
iv. Do one of the following:
• Click
Save
to save the
Name
,
EDID
, and
HDCP Support
entries for each corresponding input.
• Click
Revert
to go back to the previous settings without
saving the current entries.
• Click
Save All
to save all unsaved entries.
To delete a custom EDID file, click the
Delete…
button in the
Global EDID
section of the
page. The custom EDID file is deleted from the
Send EDID to All inputs
drop-down list and
also from each individual
EDID
drop-down list in the
Inputs
section of the page.
NOTE:
Only custom EDID files can be deleted. Built-in EDID files cannot be deleted.
Configuring Output Settings
Configuration of output settings includes the selection of an input for routing to an output,
the renaming of an output, and the enabling of HDCP. Information about the connected
display can also be viewed.
To configure output settings, do the following:
1. In the navigation bar, click
OUTPUTS
. The Output page opens.
Output Page (HD-MD6X2-4K-E Page Shown)