Crestron HD-MD4X2-4K-E - Configuring Network Settings

Supplemental Guide – DOC. 7761A HD-MD-6X2/4X2/4X1-4K-E: 4K HDMI Switchers
•
19
Configuring Network Settings
To configure network settings, do the following: On the main menu, select
Network
.
The Network Status and Configuration submenu opens.
Network Status and Configuration Submenu
< Network >
Status
Available selections are as follows:
Status
DHCP
DHCP Renew (Displayed only when DHCP is set to ON)
IP Setup (Displayed only when DHCP is set to OFF)
Items on the Network Status and Configuration submenu are listed in the following table.
Refer to the table for configuration guidelines.
Network Status and Configuration Submenu Guidelines
SUBMENU
ITEM GUIDELINES
Status (Read Only) Provides the following network-related information:
•
DHCP:
Indicates whether DHCP is on or off
•
IP Address:
Displays the IP address of the switcher
•
Subnet Mask:
Displays the subnet mask that is set on the network
•
Gateway:
Displays the IP address that is used as the network’s gateway
•
MAC Address:
Displays the MAC address of the device
DHCP
Set DHCP to
ON
or
OFF
. The default setting is
ON
. An asterisk precedes the
current setting.
DHCP Renew
(Displayed only when
DHCP
is set to
ON
) Select
DHCP Renew
to obtain a
new IP address lease.
IP Setup
(Displayed only when
DHCP
is set to
OFF
) Enter the following network-related
information:
•
IP Address:
Enter a unique IP address for the switcher.
•
Subnet Mask:
Enter the subnet mask that is set on the network.
•
Gateway:
Enter the IP address that is used as the network’s gateway
To enter an address, use the navigation pad. Press the up ( ) and down ( )
buttons as appropriate to enter each octet in an address. To move to the
previous octet in an address, press the left ( ) button. To move to the next
octet in an address, press the right ( ) button. To save an address, press the
Enter
button.



