Crestron HD-MD4X2-4K-E - Changing the Username and Password via Web Interface

12
•
HD-MD-6X2/4X2/4X1-4K-E: 4K HDMI Switchers Supplemental Guide – DOC. 7761A
•
Show video routing:
Allows the route for each output to be
shown on the OLED display. For each of the two outputs of the
HD-MD6X2-4K-E and HD-MD4X2-4K-E, the output name followed
by the corresponding input name is displayed, for example:
OUTPUT1: INPUT1
OUTPUT2: INPUT 4
For the single output of the HD-MD4X1-4K-E, the output name
followed by the corresponding input name is displayed, for
example:
OUTPUT: INPUT1
•
Disable:
Turns off the OLED display, preventing the IP address or
video routing information from being shown on the display.
In addition, the PWR LED and the INPUT and OUTPUT LEDs also
turn off.
Changing the Username and Password
To change the username and password, do the following:
1. In the navigation bar, click
DEVICE
. The Device page, which includes a
Username
and Password
section, opens.
Device Page—Username and Password
2. Do the following:
NOTE:
The username and password are case sensitive.
a. In the
Username
text box, enter the desired username.
b. In the
Password
text box, enter the desired password.
c. In the
Confirm Password
text box, reenter the desired password to
confirm the password.
d. Do either of the following:
• To save the current entries, click the
Save
button.
• To go back to the previous settings without saving the current
entries, click the
Revert
button.