Crestron HD-MD4X2-4K-E - Navigating the Web Interface

Supplemental Guide – DOC. 7761A HD-MD-6X2/4X2/4X1-4K-E: 4K HDMI Switchers
•
3
Navigating the Web Interface
The web interface provides a navigation bar and built-in web pages of the switchers.
Web Interface (Sample Status Page of HD-MD6X2-4K-E Shown)
The navigation bar provides access to the web pages as follows:
• Clicking
STATUS
accesses the Status page, which provides general information
about a switcher as well as network-related information. For additional information,
refer to “
Viewing Status Information” on the following page.
• Clicking
ROUTING
accesses the Routing page, which allows routes to be set on a
switcher. For additional information, refer to “
Configuring Routes” on page 5.
• Clicking
INPUTS
accesses the Input page, which allows the desired EDID to be
sent to the inputs. For additional information, refer to “
Configuring Input Settings”
on page 6.
• Clicking
OUTPUT
accesses the Output page, which allows the selection of an input
for routing to an output. For additional information, refer to “
Configuring Output
Settings” on page 8.
• Clicking
NETWORK
accesses the Network page, which allows network settings
such as hostname and DHCP (Dynamic Host Configuration Protocol) mode to be
set. For additional information, refer to “
Configuring Network Settings” on page 10.
• Clicking
DEVICE
accesses the Device page, which allows changes to username
and password settings and also controls various device functions. For additional
information, refer to “
Configuring Device Settings” on page 11.
NOTE:
After 10 minutes of inactivity, the web interface times out and returns to the
Login page.