Crestron Horizon HZ-THSTAT - Page 25

25 • HZ-THSTAT Product Manual — Doc. 8622E
Connection Description
TS1+ and TS1- (2) Remote sensor inputs, comprised of TS1+ and TS1- terminals;
For remote temperature sensors (CHV-RTS, CHVI-RTS-1G-N-W, and
CHVI-RTS-1G-SM-W), remote slab sensor (CHV-RSS), remote temperature and
humidity sensors (CHV-RTHS), and 10k thermistors (all sensors and thermistors are
sold separately);
Connect up to (2) Crestron temperature sensors, (1) Crestron
temperature/humidity sensor, or (1) 10kthermistor;
Can be designated as an autochangeover sensor for an FCU 2-pipe heat/cool
system
NOTE: TS1+ and TS1- connections are non-polarized. The + and - designations
are provided to simplify wiring.
TS2+ and TS2- (2) Remote sensor inputs, comprised of TS1+ and TS1- terminals;
For remote temperature sensors (CHV-RTS, CHVI-RTS-1G-N-W, and
CHVI-RTS-1G-SM-W), remote slab sensor (CHV-RSS), remote temperature and
humidity sensors (CHV-RTHS), and 10k thermistors (all sensors and thermistors are
sold separately);
Connect up to (2) Crestron temperature sensors, (1) Crestron
temperature/humidity sensor, or (1) 10kthermisto;
Can be designated as an autochangeover sensor for an FCU 2-pipe heat/cool
system
NOTE: TS2+ and TS2- connections are non-polarized. The + and - designations
are provided to simplify wiring.
USB (1) Micro B female, USB 2.0 computer console port for firmware upload, temporary
power, and device configuration.