Crestron Horizon HZ-THSTAT - Humidstat Setup

Product Manual — Doc. 8622E HZ-THSTAT • 90
l
TS1 Usage: Defines how remote sensor channel 1 is used by the thermostat.
o
Omit: (Default) Omits channel from thermostat operation
o
Space: Adds channel to space temperature/humidity average
o
Outdoor: Adds channel to outdoor temperature/humidity average
o
Floor: Adds channel to slab (floor) temperature average
l
TS2 Usage: Defines how remote sensor channel 2 is used by the thermostat.
o
Omit: (Default) Omits channel from thermostat operation
o
Space: Adds channel to space temperature/humidity average
o
Outdoor: Adds channel to outdoor temperature/humidity average
o
Floor: Adds channel to slab (floor) temperature average
l
Wall Type: Defines the wall type that the thermostat is installed into for accurate temperature
readings. Select Non-Insulated (hollow) or Insulated.
l
Local Sensor Temperature Trim: Adjusts local sensor temperature measurement. Select -6 to
+6for Fahrenheit (-3.0 to +3.0 for Celsius). The default setting is 0.
l
TS1 Temperature Trim: Adjusts temperature sensed by temperature sensor(s) attached to TS1
input. Select -6 to +6for Fahrenheit (-3.0 to +3.0 for Celsius). The default setting is 0.
l
TS2 Temperature Trim: Adjusts temperature sensed by temperature sensor(s) attached to TS2
input. Select -6 to +6for Fahrenheit (-3.0 to +3.0 for Celsius). The default setting is 0.
l
Local Sensor Humidity Trim: Adjusts local sensor humidity percentage. Select -9.0 to+9.0. The
default setting is 0.
l
TS1 Humidity Trim: Adjusts humidity percentage sensed by temperature/humidity sensor
attached to TS1 input. Select -9.0 to +9.0. The default setting is 0.
l
TS2 Humidity Trim: Adjusts humidity percentage sensed by temperature/humidity sensor
attached to TS2 input. Select -9.0 to +9.0. The default setting is 0.
Humidstat Setup
Select Humidistat Setup and then configure these settings:
l
Invert Call Logic: Change the HUM relay control logic for a humidifier or dehumidifier expecting a
Normally Closed (NC) input. To invert the call logic, turn on the switch. The default setting is off
for a Normally Open (NO) input.