Crestron Mercury CCS-UC-1 - DEVICE Management; Firmware

Supplemental Guide – DOC. 7844E CCS-UC-1: Crestron Mercury Tabletop Conference System • 15
5. Enter the user name and password in the Server Username and Server Password
fields.
6. Enter the name of the SIP server realm in the Server Realm field.
NOTE: Many SIP servers do not require a realm and the default value “*” can be
used.
7. Enter the local extension number in the Local Extension field.
8. Enter the SIP proxy server’s IP address or host name in the Proxy Server field.
NOTE: A proxy IP address is not always required. When a proxy IP address is not
required, the default value “NONE” can be used.
9. Select the Ethernet port on the CCS-UC-1 to use for SIP calling. Select Adapter 1
if the LAN port on the CCS-UC-1 connects to the SIP server. Select
Adapter 2 if
the AUX port on the CCS-UC-1 connects to the SIP server.
10. If server validation is not used, set Enable Server Validation to Disabled.
Otherwise, set
Enable Server Validation to Enabled and select the trusted
certificate authorities to use.
• To select all of the authorities, click the check box next to the search box. To
unselect all of the authorities, click the check box again.
• To search for a specific authority, start typing the name of the authority in the
search box and check the boxes next to the desired authorities.
• To load a custom certificate, click Manage Certificates and follow this
procedure:
a. Click the SIP tab to manage certificates for use with a SIP server. If
present, the current SIP certificate is displayed.
Manage Certificates: SIP Tab
b. Click Add SIP Certificate.
c. Click Browse, select the certificate file, and click Open.
d. When prompted, enter the password used to encrypt the file.
e. Click Load to upload the certificate to the CCS-UC-1. A message
confirming the upload is displayed.
f. Click OK to close the Add Certificate screen.
11. Click Save Changes to apply any changes. Click Revert to revert back to the
previously used settings.
12. Verify the status of the connection to the SIP server in the Status field.