Supplemental Guide – DOC. 7927G TSW-560/TSW-760/TSW-1060: Touch Screens• 53
Applications
Click Applications to a select an application to run on the touch screen.
Settings Tab - Applications
Use the Application Mode drop-down menu to select a touch screen application from
the available selections.
User Project is selected by default, which is used when a custom
project is loaded to the touch screen.
Once a new application is selected, click Save Changes from the Actions menu. A
pop-up dialog box is displayed stating that the touch screen must be rebooted for the
new application to take effect. Click
Yes to reboot the touch screen now or No to reboot
the touch screen later.
The touch screen reboots with the new application running.
NOTE: Each application uses a unique setup procedure for registering and configuring
the application. For more information on setting up each application, refer to
"Application Setup" on page
54.
Auto Update
Click Auto Update to configure automatic firmware updates for the touch screen.
Settings Tab - Auto-Update
• Auto Update: Toggle the switch to enable or disable automatic firmware
updates.
• When Auto Update is enabled, the touch screen connects to a secure Crestron
file server to check for new firmware at an established time outside of business
hours (02:00 local time). If new firmware is available, the touch screen attempts
to download and install the firmware.
• Click Update Now to check the file server for new firmware and to update the
touch screen immediately if new firmware is available.
To Next Page
Loading...
