Crypto ReDi 40 MP - User Manual

Other manuals for Crypto ReDi 40 MP

Questions and Answers

H
hmarquezAug 10, 2025
Why is my Crypto ReDi 40 MP not responding to the remote control?
- B
  Betty DuncanAug 10, 2025
  If your Crypto Receiver is not responding to the remote control, consider the following possibilities: * Ensure the receiver is plugged in and turned on. * Aim the handset directly at the front panel of the receiver. * Check for any obstructions blocking the remote sensor or reposition the sensor. * Replace the remote battery. * Make sure the remote sensor plug is fully inserted into the remote sensor socket on the main unit.
P
petersshellyAug 15, 2025
What to do if my Crypto Receiver says no signal?
- K
  Kirsten MyersAug 15, 2025
  If your Crypto Receiver is showing 'No signal found', the issue might be with the aerial. Check if the aerial lead is disconnected or if the aerial itself is damaged. It's also possible that you are out of the digital signal area, in which case you should check with your signal provider.
J
Joseph JohnsonAug 20, 2025
How to fix a Crypto ReDi 40 MP Receiver with no standby light?
- J
  John MartinezAug 20, 2025
  If the standby light on your Crypto Receiver is not lit, check the following: * Ensure the mains lead is properly plugged in. * Check the mains fuse. * Verify that the remote sensor plug is fully inserted into the remote sensor socket on the main unit.
D
Dean TurnerAug 25, 2025
What to do if my Crypto ReDi 40 MP Receiver shows a scrambled channel message?
- A
  aaron32Aug 25, 2025
  If your Crypto Receiver displays a scrambled channel message, it indicates that the channel is scrambled. To resolve this, simply select an alternative channel.
X
xmullinsAug 30, 2025
Why Crypto Receiver is not receiving digital signal after moving to another room?
- B
  Brandi SilvaAug 30, 2025
  If your Crypto Receiver is no longer able to receive a digital signal after being moved to another room, this could be due to distribution problems causing the signal through the aerial to be not strong enough. Try a direct feed from the antenna.
R
Robert JohnsonSep 4, 2025
How to reset the channel lock code on a Crypto ReDi 40 MP Receiver?
- J
  Janice BryantSep 4, 2025
  If you have forgotten the channel lock code for your Crypto Receiver, re-installing the channels will cancel the channel lock.