CS Instruments FA 550 - Sensor Settings

Operation
Page 22 FA 550 V1.00
12.3.1 Sensor Settings
Settings  Sensor Setup
12.3.1.1 Definition of units for Temperature, pressure and abs. humidity
Settings  Sensor Setup Units
For changes, first select the menu item with
key „ “ and then confirm it with “OK“.
To make changes to the unit for the respective
measurement value, first select by pressing
„“ the field of the „measurement value“ and
activate „it with „OK“ .
Selection of the new unit with „“
In case the quantity of units selectable are not
presentable on one page, pleas move to next
page by pressing „<<“ .
Confirm selection by pressing 2x „OK“.
Procedure for all 3 measurements variables is
analogous.
Leaving the menu with „back“