Cub H16 - Connection to 240 Volt Electricity

© CUB CAMPERS • H16 OWNER’S MANUAL • REVISION 1 – 31/10/2023 PAGE 24 of 53
CONNECTION TO 240 VOLT ELECTRICITY
A 15A extension lead is required to connect the H16 to a 240V power supply e.g., at your home
or at a caravan park. Plug the 15A lead into the 240V Power Inlet located on the outside
driver’s side wall of the caravan. Locate the change over switch in the electrical hatch and turn
to “mains” from “off”.
The 240V breaker switch is located on the left of the 240V Power Inlet as shown in the image
on the right below.
Be sure to test the breaker switch by pressing the test button before travelling or once a
month.
Seek out & pay attention to instructions (per AS/NZS 3001.2 Appendix B) which should be
provided by the operator of any site supply which you may wish to connect your Caravan.