© CUB CAMPERS • H16 OWNER’S MANUAL • REVISION 1 – 31/10/2023 PAGE 4 of 53
o Make sure HWS fuel supply is shut off.
o All storage lockers outside are closed and locked.
o Outside toilet door is locked and the flush water tank is less than half full and the waste
holding tank is empty or not more than ¾ full to avoid leakage.
o Fresh water tanks are full, grey water is empty, and water tank box is secured. Make
sure you have packed the “drinking water” hoses.
o Stabiliser legs are wound up and secured.
o Roof is lowered and secured properly.
NOTE:
• Learners, P1 license holders and provisional motorcycle riders are not allowed to tow.
• You must not tow more than 1 trailer at a time.
• You must not obscure vision to reflectors, brake light, indicator lamp or number plate.
• You must secure and cover your load, making sure it does not overhang.
• During the trip, make sure coupling, all doors, hatches, covers and any load or
equipment, are still properly secured.
• By law in Australia if you are towing anything wider than your vehicle, towing mirrors
are required.
• It is illegal to ride in a caravan when it is being towed.
2. PACKING THE H16
The CUB H16 features a design style where most of the storage space is located forward of
the axle. This aspect needs to be carefully considered when packing the H16 for travel to
ensure that the maximum weight applied to the towbar of the tow vehicle is not exceeded.
The most stable, sway-free towing condition is achieved when the total ball load is within 7-
10% of the caravan’s ATM. The ATM, Ball weight and TARE are stamped on your vans VIN plate
to assist with this calculation.
Do not overload the caravan forward of the axle with weights that will result in the total ball
weight exceeding 10% of the ATM. Do not exceed maximum allowable tow-ball mass of the
tow vehicle.
Before travelling, make sure all doors, vents, and hatches are closed and windows are locked
in the air lock position with the latch pin in front of the catch. (The middle position is for
ventilation to help reduce condensation it will not give a dust proof seal in this position.)
To Next Page
Loading...