© CUB CAMPERS • H16 OWNER’S MANUAL • REVISION 1 – 31/10/2023 PAGE 31 of 53
HOT WATER OPERATION
1. ADJUST TEMPERATURE VALVE
Adjust the mixing valve half way between max. hot and max. cold (half turn).
2. SWITCH WATER PUMP ‘ON’
Locate the 'POWER' switch on the inside of the entry door to the left and switch 'ON' (LED
lamp will alight). Note: Switch 'OFF' at night to avoid being woken by the pump periodically
re-pressurizing the system.
3. SWITCH ON
Switch on the water heater at the switch on the control panel, see below.
Control Panel:
1 Menu Name
2 Menu Symbols
3 Time Setting Activated
4 Time
5 On / Off Button
Red LED - Fault
White LED – Off
Green LED – On
6 Control Knob
4. SWITCH SYSTEM ‘OFF’
Switch off the heater by pressing the on/off button. If you turn the heater off by the
main power supply the combustion will be extinguished, followed by a shutdown cooling
cycle of approximately 90 seconds.
PRODUCT REGISTRATION
To commence the 2-year warranty, the product should be registered on the Webasto Dealer
Portal. If you do not have access, email the following to: svc-WTAUtechnical@webasto.com
PRODUCT NAME & SERIAL NUMBER
VEHICLE MAKE, MODEL, VIN, YEAR & REGISTRATION NUMBER
END USER or MANUFACTURER SUBURB/TOWN & STATE/TERRITORY
To Next Page
Loading...