CUBICON Style Plus-A15 Series User Manual
Printing would be proceeded in the following order:
Heating → Z-axis Auto Leveling → Filament Existence/Flow Detection → Printing
● Heating: Heating operation is performed according to the data that has been configured in
Cubicreator.
Heating is performed on the Extruder and the Bed simultaneously.
● Z-axis Auto Leveling: It makes precise printing possible by measuring the height of 9 points of the
Bed. However, the leveling takes place only once initially after the power is supplied if Setting >
Function > Auto Leveling is set to OFF.
When leveling, preheat the extruder to a temperature lower than 50 ℃ based on the printing
temperature and perform leveling. Preheating at printing temperature Pre-heating and leveling at
output The waiting time may be longer due to temperature setting.
● Filament Existence/Flow Detection: It checks whether the filament exists/flows, and it performs
the auto loading if there is no filament in the Extruder.
● Printing: It prints stably at high quality by applying the enhanced PGM algorithm.
48
To Next Page
Loading...