CUBICON Style Plus-A15 Series User Manual
Since the temperature of the Extruder part raises during printing, do not touch it.
When opening the Extruder cover, check whether there is any obstacle underneath the
Extruder.
Disassemble or assemble the Extruder model only after the power is turned off and the
temperature of the nozzle is sufficiently cooled down.
Mounting the Clean Filter
After removing vinyl packing of the clean filter, insert the clean filter into the clean filter case on the right
side inside the main body of the printer.
Mount a clean filer into the case in the correct direction. (The arrow must point to the
outside)
If the mounting direction is incorrect, the performance of the filter would be lowered, and it
may cause a failure of the filter fan.)
Replacement of a clean filter must take place after confirming that the power is turned off.
During the replacement, be cautious not to let any foreign substance get in.
To Next Page
Loading...
Need help?
General