CUBICON Style Plus-A15 Series User Manual
Settings
It is a screen that can check/set up various setting values of the device and configure the functions such
as communication network settings and language settings.
Also, the upgrade of the device can be supported and the printing history info can be checked.
Settings(Function)
● Auto Leveling: It configures the Auto Leveling function during printing. It is performed only once
initially after the power is applied if it is configured to be OFF.
● Filament Check: It configures the detection whether the filament exists. After it is configured to
be ON, a user can’t proceed with the printing if the filament does not exist or it is not detected. If
the material is used up, the printing would get suspended automatically in Pause state.
● Filter Fan: It is a function to turn ON/OFF the filter fan that is attached on the device.
● Visible Menu Label: It can configure whether to display the function display area label.
● File Sorting: It decides the list sorting method of the File screen.
● Sound: It can adjust the sound volume of the device.
● Z Offset: It can adjust the 9 point Z-axis offset values of the bed.
39
To Next Page
Loading...
Need help?
General