CUBICON Style Plus-A15 Series User Manual
3. Printing
If you have successfully installed the product according to Chapter 2. Components and Installation earlier,
it is recommended to print a sample that is stored in the internal memory in order to test whether the
device operates normally.
After selecting Internal Memory under File, go to the sample folder.
Among files, select the 20180912_snowman_01(Style Plus-A15_PLA).cfb file.
PLA material must be mounted on the filament spool.
If the preparation is completed, start printing by pressing the button.
Once transmission of the printing file is completed, the following Print screen would be activated, and the
printing progress status can be monitored in real-time.
47
To Next Page
Loading...
Need help?
General