Cubicon Style Plus-A15 Series - Page 20

CUBICON Style Plus-A15 Series User Manual
Names of Each Part of the Extruder (Extruder)
[E1] Filament Inlet
It is an inlet that is used to insert a
filament into the extruder.
Teflon tube is inserted.
The filament hose is fixed using
one-touch fitting so that it wouldn’t
be taken off.
[E2] Filament Push
Handle
A handle that is pushed when the
filament inside of the extruder is
manually taken out or inserted.
[E3] Mold Fan
A fan that sends air toward a
sculpture
[E4] Heating Block
Cover
A cover that surrounds the nozzle
heating block (heat-resisting
rubber)
[E5] Nozzle
A nozzle that a filament which has
been melted gets pushed out
[E6] Extruder Cable
A cable that has a role of supplying
power and transmitting a signal as
it is connected to the extruder
[E7] Cable Fixing bolts
Bolts for fixing a cable to the
extruder (M2.5)
[E8] Cable Fixing
Block
A device that fixes the extruder
cable to the extruder so that it
would not be taken off
[E9] Cool End Fan
A fan that cools down the heating
block
[E10] Extruder Module
Fixing Bolt
A fixing bolt that is used when
separating the extruder module
[E11] Gear Fan
A fan that cools down gears inside
of the extruder
[E12] Extruder Cover
A cover for checking inside of the
extruder
20