User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 6 - 10 Encryption
© 2024 Curtiss-Wright Defense Solutions Revision 3.0
1. Type rmcctl --force -C and press ENTER key.
NOTE
After the above command has be issued, the user must acknowledge that all data on the disk will
be overwritten
2. At the overwrite query prompt type YES and press E
NTER key.
NOTE
Refer to paragraph 6.1.2 Software Layer Passwords / Passphrases for requirements.
3. Enter a password / passphrase that complies with the password / passphrase requirements
and press E
NTER key.
4. Reenter the password / passphrase and press ENTER key.
If the passphrase is entered correctly both times and meets the requirements the following
message will be displayed: RMC_C0; action=cryp status=OK.
Example
5. Verify SWE container is initialized.
Command:
rmcctl
If SWE container is initialized, scryp = 1
Example
6.4.1.2 Open SWE Container (Unpartitioned Disk)
NOTE
The SWE container must be opened before it can be used.
Open the SWE container on an RMC module as follows:
NOTE
After five failed attempts to open the SWE container, the DTS1+ CSfC will reboot and another five
attempts be granted.
1. Type rmcctl -E password / passphrase and press E
NTER key.
If the passphrase is entered correctly the following message will be displayed:
RMC_C0; action=enter status=OK ‘Resetting attempts to 0’.
Example
2. Verify SWE container is open.
Command:
rmcctl
If SWE container is open, osdm = 1
cw_dts> rmcctl -C password / passphrase
[rmcctl]
Please verify password: password / passphrase
RMC_CO; action=cryp status=OK
[!rmcctl] OK
cw_dts> rmcctl
[rmcctl]
RMC_S#: ins hcryp osdr p# size serv scryp osdm fmt mnt rem mntpoint
*********************************************************************************
RMC_S0: 1 1 1 -- 100GB NAS
1 0 0 0 0 rmc0
[!rmcctl] OK
cw_dts> rmcctl -E passphrase
[rmcctl]
RMC_CO; action=enter status=OK ‘Resetting attempts to 0’
[!rmcctl] OK
To Next Page
Loading...