Curtiss-Wright DTS1+ CSfC - Figure 5.1 DTS1+ Csfc Chassis Anti-Tamper Label Locations

To Next Page

To Previous Page

User Guide DDOC0199-000-A9

1-Slot Data Transport System (CSfC) 5 - 1 Installation

Installation

CAUTION

EQUIPMENT DAMAGE. Exercise ESD precautions when installing, removing, or handling the

DTS1+ CSfC.

5.1 Package

NOTE

Either L-brackets or a Dzus mount is included depending on the ordered configuration.

The DTS1+ CSfC package contents are listed below:

• DTS1+ CSfC Chassis

• L-Brackets*

• Dzus Mount*

• Product Documentation CD

Optional Items (Refer to Ordering Information section for part numbers).

• RMC Module(s)

• Power Lab Cable

• Utility Lab Cable

• Ethernet Lab Cable

5.2 Inspection

The DTS1+ CSfC is a two-part data storage system that consists of a DTS1+ CSfC chassis and a

RMC module. Additional accessories may be included (if ordered). All received items should be

inspected for damage. Inspect all units as follows:

• All screws should be tight.

• The door gasket should be free from any cuts, crushing, or flattening damage

• All anti-tamper labels (Figure 5.1 and Figure 5.2) should be unbroken.

• All components should be free from any dents, cracks, or damage.

• All connectors pins should be present, straight, and undamaged.

If the DTS1+ CSfC chassis or any accessories were damaged in shipping or the enclosure was

breached, immediately notify Curtiss-Wright Defense Solutions or your supplier.

Figure 5.1 DTS1+ CSfC Chassis Anti-Tamper Label Locations

Anti-Tamper Label Locations

DDOC0199-0013