User Guide DDOC0199-000-A9
1-Slot Data Transport System (CSfC) 4 - 4 Controls and Indicators
© 2024 Curtiss-Wright Defense Solutions Revision 1.0
4.3.4 Removal Request Button
CAUTION
EQUIPMENT DAMAGE. Exercise ESD precautions when installing, removing, or handling the
RMC module.
CAUTION
EQUIPMENT DAMAGE. The RMC module is hot-swappable (remove / install with power applied),
however, extreme caution must be used to ensure all ESD handling precautions are followed.
Press and hold this button for three to five seconds to request removal of the RMC module. The
STATUS LED will blink at 5Hz for two seconds to acknowledge the request. After
acknowledgment, the system will unmount and prepare the RMC module for removal. When the
RMC module is ready for removal, the STATUS LED will blink one time every five seconds.
Removal may also be requested with the CLI command rmcctl.
To Next Page
Loading...