Curtiss-Wright DuraCOR 311 - Connector Pinouts; J1 Power Connector; Figure 11: Duracor 311 J1 Front Pinout; Table 5: J1 Connector Information

DuraCOR 311
Chapter 4 Connector Description
Page 24 of 72
MNL-0667-01 Rev B2
ECO-5941
Effective: 17 Mar 20
Connector Pinouts
This section provides the pinouts necessary for creating cables to connect to this assembly. If custom
cabling is not designed and built by Curtiss-Wright, all EMI and EMC consideration must be handled by
the customer.
There are four internal connectors for configurable I/O. Each internal connector is labeled as P4, P5, P6,
or P7. J2-J4 pinout tables (Table 8, 10, and 12) contain a column for the internal configurable I/O
connectors.
Example:
J2
Pin
Signal Name
Description
Px Pin
J2_1
CONFIGURABLE_IO_79
P7_14
Connector J2, pin 1 is a configurable I/O which is internally attached to connector P7, pin 14.
See Configurable I/O Internal Connectors section below for location and part numbers.
J1 Power Connector
Figure 11: DuraCOR 311 J1 Front Pinout
Table 5: J1 Connector Information
Receptacle
Use
Receptacle
Label #
# of
Pins
Wire Gauge
(AWG)
Amphenol (Glenair) Jam
Nut Receptacle
Part Number
Amphenol (Glenair)
Mating Connector
Part Number
Power
J1
3
22-28
2M801-033-07M5-3PA
(801-033-07M5-3PA)
2M801-008-16M5-3SA
(801-008-16M5-3SA)
Table 6: J1 Pinout
J1 Pin
Signal
A
+VDC
B
VDC_RTN
C
CHASSIS_GND