Curtiss-Wright DuraCOR 311 - Test Cable Set - CBL-C31 X-01; Figure 17: CBL-C31 X-01 Starter Cable Set; Table 14: CBL-C31 X-01

DuraCOR 311
Chapter 4 Connector Description
Page 32 of 72
MNL-0667-01 Rev B2
ECO-5941
Effective: 17 Mar 20
Test Cable Set – CBL-C31X-01
A test cable set with the IO broken out to commercial connectors for a base DuraCOR 311 is available for
purchase.
Figure 17: CBL-C31X-01 Starter Cable Set
Table 14: CBL-C31X-01
CW Part Number
Description
CBL-2677-01
C31X Lab Power Cable, J1, 6ft
CBL-2678-01
C31X Lab Cable, USB, ETH, Remote On/Off, etc., J2, 6ft
CBL-2679-01
C31X Lab Cable, HDMI, COM, GPIO, J3, 6ft
Note: On CBL-2679-01 there are three DB9 connectors labeled console, CAN 1 and CAN 2. These
interfaces are not implemented on the DuraCOR 311. The cable set is common to the DuraCOR 310
(See DuraCOR 310 User Manual for more information). If CAN is required on the DuraCOR 311, a
mPCIe CAN card may be implemented, see Chapter 2.