Curtiss-Wright DuraCOR 311 - Setup Guide; Menu Bar; Legend Bar; Selecting an Item

DuraCOR 311
Appendix C – BIOS Settings
MNL-0667-01 Rev B2
ECO-5941
Effective: 17 Mar 20
Page 47 of 72
Setup Guide
The Setup Utility changes system behavior by modifying the Firmware configuration. The setup program
uses a number of menus to make changes and turn features on or off.
Functional keystrokes in POST:
[F2]
Enter Setup
[F5]
Boot Menu
[ESC] + [2]
Enter Setup via Remote Keyboard in Console Redirection
Mode (depending on console Settings F2 may not be
supported)
Functional keystrokes in Setup:
[F1]
Help
[F9]
Load default settings
[F10]
Save and Exit
Menu Bar
The menu bar at the top of the window lists different menus. Use the left/right arrow keys to make a
selection.
Legend Bar
Use the keys listed in the legend bar on the bottom to make your selections or exit the current menu. The
table below describes the legend keys and their alternates.
Key
Function
← or → Arrow key
Select a menu.
↑ or ↓ Arrow key
Select fields in current menu.
<Home> or <End>
Move cursor to top or bottom of current window.
<PgUp> or <PgDn>
Move cursor to next or previous page.
+/- or F5/F6
Change Option
<Enter>
Execute command or select submenu.
Selecting an Item
Use the ↑ or ↓ key to move the cursor to the field you want. Then use the + and – keys to select a value
for that field. The Save Value commands in the Exit menu save the values displayed in all the menus.
Displaying Submenus
Use the ← or → key to move the cursor to the submenu you want. Then press <Enter>. A pointer (►)
marks all submenus.
Item Specific Help Window
The Help window on the right side of each menu displays the Help text for the selected item. It updates
as you move the cursor to each field.