Curtiss-Wright DuraCOR 311 - Page 54

DuraCOR 311
Appendix C – BIOS Settings
Page 54 of 72
MNL-0667-01 Rev B2
ECO-5941
Effective: 17 Mar 20
Feature
Value/Options
Description
PCB Temperature
xx°C
Shows the measured temperature of
the printed circuit board
NCT782Y Temperature
xx°C
Shows the measured temperature of
the NCT782Y Hardware monitor
CPU FAN
xxxx rpm
Shows the fan speed of onboard FAN
connector
Fan Pulse
2
Number of pulses the CPU fan
produces during one revolution.
Range 1-4
FAN Control
Disabled
Manual
Auto
Set fan control mode. 'Disable' will
totally stop the fan
Fan Trip Point
45
Temperature where fan accelerates.
Range 20 - 80°C
Trip Point Speed
50
Fan speed at trip point in %. Minimum
value is 30. Fan always runs at 100%
at Tjmax - 10°C
Reference Temperature
PCB Temperature
NCT782Y Temperature
Determines the temperature source
which is used for automatic fan control
External FAN
xxxx rpm
Shows the fan speed of external
COMe FAN
Fan Pulse
2
Select the number of pulses the
external fan produces during one
revolution. Range 1-4
FAN Control
Disabled
Manual
Auto
Set fan control mode. 'Disable' will
totally stop the fan
Fan Trip Point
45
Temperature where fan accelerates.
Range 20 - 80°C
Trip Point Speed
50
Fan speed at trip point in %. Minimum
value is 30. Fan always runs at 100%
at Tjmax - 10°C
Reference Temperature
PCB Temperature
NCT782Y Temperature
Determines the temperature source
which is used for automatic fan control
DDR voltage
x.xx V
Shows the Module Main Input Voltage
Input voltage
x.xx V
Shows the 5V Standby Voltage input
RTC battery
x.xx V
Shows the RTC Battery Voltage input
measured at COMe connector