CODE TABLE [num]
setting of two digits for the tens and the units:
CODE TABLE [num x 10]
Setting the digit for tens:
0
D
2 4 6 8
1 3 5 7 9
CODE TABLE [num x 1]
Setting the digit for units::
0
D
2 4 6 8
1 3 5 7 9
NOTE:
with this parameter.
The character tables set with this parameter are the same set with the command 0x1B 0x74 (refer to the
Commands Manual of the device).
PRINT DENSITY Adjusting the printing density:
-25%
-12%
0
D
+12%
+25%
48
To Next Page
Loading...
Need help?
General
