10
TRUSCULPT OPERATOR MANUAL
D1395, REV. K, 02/18
3. Turn the key to the (START) position, then release.
Turning on the system engages the pump, allowing the water to be drawn into the cooling
system.
4. Allow the system to run for 5 to 10 seconds.
5. Turn the key to the
(OFF) position.
6. Carefully top off the reservoir.
7. Repeat steps 3 through 6 until the reservoir is full.
8. Replace the reservoir cap.
NOTE
The coolant capacity of the system is approximately 1 liter.
To Next Page
Loading...
