34
TRUSCULPT OPERATOR MANUAL
D1395, REV. K, 02/18
Cleaning the Neutral Electrode Cable
Clean the neutral electrode cable with warm, soapy water and a soft brush or sponge. Ensure that the
cable and clamp are completely dry after cleaning.
To avoid damage, do not use harsh abrasives or chemicals to clean the neutral electrode cable, do not
immerse the cable in the cleaning solution, and do not steam sterilize the cable.
Checking the Water Level
Check the water level in the coolant reservoir monthly. If the water needs to be topped off, refer to the
Filling the Coolant Reservoir section in the Introduction chapter for details.
Warranty Information
For specific and detailed warranty information for your Cutera console platform, please refer to the first
page of your purchase “Agreement” and the last page of the “Terms and Conditions of Sale.”
Product Complaints
All questions or concerns related to the quality, reliability, and/or durability of this product should be
directed to Cutera Customer Service or to an authorized Cutera representative. If it is necessary to return
any equipment, contact Cutera Customer Service or an authorized Cutera representative for a return
authorization.
End of Life Disposal - Environmental Information
The truSculpt system must be disposed of according to local laws and hospital practices. This product is
considered electronic equipment and must not be disposed of as unsorted municipal waste and must be
collected separately. Please contact the manufacturer or other authorized disposal company to
decommission your equipment.
Proper disposal of electronic equipment is required according to EU Directive 2002/96/EC Waste
Electrical and Electronic Equipment (WEEE).
CAUTION
Before disinfecting the neutral electrode cable, ensure that the
system is either turned OFF or in STANDBY mode.
To Next Page
Loading...
