91
15. Enviroment setting■
■ Read only mode
Constants only could be read, and not modified after set Cd98=0. The rest of constants are locked,
beside Cd98, Cd00 frequency command and Cd15 jog frequency could be modified. Select sequence of
constants like simple mode at read mode.
■ Macrocosm mode
All constants could be read and modified after set Cd98=2.
■ Simple mode
The constant setting were modified to be simple mode after set C98=1. Simple mode provides 20
common use constants for operators to use and modify, the sequence as below:
Sequence Constant NO. Constant name Page
1 Cd00 Frequency setting P42
2 Cd01 Frequency command selecting P44
3 Cd02 Operation display content P43
4 Cd04 Operation command selecting P45
5 Cd05 V/F curve selecting P57
6 Cd06 Motor rated current P62
7 Cd08 Acceleration time 1 P45
8 Cd09 Deceleration time 1 P45
9 Cd12 Frequency command 2 P53
10 Cd13 Frequency command 3 P53
11 Cd14 Frequency command 4 P53
12 Cd15 Jog frequency P55
13 Cd44 Stop method selecting P46
14 Cd51 Motor rated voltage P60
15 Cd53 Maximum output frequency P60
16 Cd54 Maximum output voltage P60
17 Cd56 Middle output voltage P60
18 Cd58 Minimum output voltage P60
19 Cd61 PWM frequency selecting P89
20 Cd98 Data lock P91
To Next Page
Loading...
