4.
Press or to highlight Add/Delete Analog Channel.
5.
Press or to select Added or Deleted.
6.
Press the SETUP button to return to the previous menu.
To exit, Press the SETUP button until the programming menus disappear. If there are more
analog channels to be added or deleted, repeat steps 3 through 5.
7.
Press or to highlight Enable/Disable Digital Channel.
8.
Press to select Enable/Disable Digital Channel.
If there are not any channels programmed in the Service Level, No Channels Present will appear
in the menu.
9.
Press or to highlight the digital channel that needs to be enabled or disabled.
10.
Press or to select Enable or Disable.
11.
Press the SETUP button to return to the previous menu.
Features
1.
Press or to select Features.
Page 41 of 82
Cybex 525AT Arc Trainer Part Number 5525-4 F
To Next Page
Loading...
Need help?
General
