Qty.Description
16’ Coax Cable1
1Coax Cable Connector2
Visually inspect unit
1. Remove any packing material from unit.
2. Examine the unit to ensure that the assembly is correct and complete.
Setup
Use the following instructions to setup the unit.
1. Plug the power cord into a power outlet from a grounded circuit.
Coil up the remainder of the power cord and place it out of the way. The control panel will light up
and be in the Dormant Mode.
2. Hold the handrails to steady self while stepping into the foot plates.
3. Begin striding.
Time and Date confirmation
The first time the unit is turned on, it prompts the user to confirm the current Time and Date. Quick Start,
Workouts, Setup or Stop will skip this requirement but it will appear again the next time the unit is
powered up until the time and date are properly set.
1.
Press the ENTER key to begin editing the time, starting with the hours (HH) and then minutes
(MM) and then AM/PM/24.
2.
Press the UP and DOWN keys to select the hour.
3.
Press the ENTER key to accept and begin editing the minutes.
4.
Press the UP and DOWN keys to select the minutes.
5.
Press the ENTER key to accept and begin editing the AM/PM/24 hour setting.
Page 25 of 82
Cybex 525AT Arc Trainer Part Number 5525-4 F
To Next Page
Loading...
Need help?
General
