When storing FM presets, this button will clear all stored FM radio
presets. Toggles near/far for UHF receiver sensitivity.
Setup key11
Enters menu, accepts value shown, moves forward in menu.Enter key12
Navigates TV channels or manually tunes FM frequenciesUp/Down keys13
A/V setup mode
1. Plug the optional power cord into a power outlet from a grounded circuit, See Electrical Requirements.
Coil up the remainder of the power cord and place it out of the way. If you do not have the optional
power supply, skip to step 3.
2. Verify the control panel will illuminate and is in Dormant Mode.
3. Hold the handrails to steady self while stepping into the pedals.
4. Begin pedaling.
5.
Press and hold SCAN and Up for 3 seconds.
Display will show clock icon.
6.
Press Down to navigate to the A/V screen.
7. Press Enter to enter setup mode.
8.
Press the Up or Down keys to change A/V type from none to UHF or FM.
9. Plug in headphones to listen for channels during setup.
Setup UHF Transmitters
1.
Press and the hold the Display option and UP keys for 3 seconds.
Display will show time setup.
2.
Press Down to navigate to the A/V setup screen.
Press the ENTER key.
3.
Press the UP and Down keys to select UHF.
4.
Press the ENTER key.
Page 32 of 80
Cybex 525C/525R Cycle Part Number LT-24303-4 E
To Next Page
Loading...
