50
Cybex Owner’s Manual
Stopping the Treadmill
Press STOP once to end the workout session and start the Workout Review. The treadmill will
perform a controlled belt stop and bring the incline to 0%. The accumulated data or the results of
the Fitness Test will be displayed for the duration congured in Setup for Review Time. Press STOP
again to exit to Dormant.
The function of the immobilization method: The purpose of immobilizing the treadmill is to prevent
unauthorized use. This can be accomplished by removing the e-stop key from the treadmill, un-
clipping it from the cord and putting it in a non-accessible place.
STEPS
DISTANCE CALORIES CAL / HR BPMPACE TIMEMETs
COOL
INCLINE
END
PAUSE
SCAN
SHIFT
DOWN
FIT TEST
MANUAL
PROGRAMS
31 2
WEIGHT
CLEAR ALT
LEVEL
7
4
SPEED
ENTER
9
0
8
5 6
TIME SAVE
FAN OFF
FAN LO
FAN HI
START
QUICK
The emergency dismount: Follow the steps listed below if you experience pain, feel faint or need to
stop your treadmill in an emergency situation:
1. Grip handrails for support.
2. Step onto the top steps.
3. Pull the e-stop key off the console.
The function of the emergency stop: The e-stop key functions as the emergency stop. In an
emergency situation, remove the e-stop key from the treadmill and the running belt will come to a
stop.
Safety Sentry
Safety Sentry uses display feedback to determine user presence. If a user is not detected within 10
seconds, the display beeps and inquires “run?” (LED console) or “Are you there?” (E3 View console).
The treadmill will use every sensor available to determine a user is still on the belt before asking if
you are present, then shutting it off. If the user is lighter than 100 lbs. (45 Kg), the motor drive may
not be able to determine they are on the belt. In this instance, the treadmill can only rely on the key
inputs, or the heart rate to establish your presence. It is advisable for lighter users to take advantage
of the wireless heart rate feature to avoid triggering the Safety Sentry.
To Next Page
Loading...
Need help?
General
