25
Cybex Owner’s Manual
Setup
Use the following instructions to setup the units settings.
WARNING: Falling hazard.
When starting unit.
• Stand on two top steps.
• Do not stand on belt.
1. Without anyone on the unit, plug the power cord into a power outlet from a grounded,
dedicated circuit as described under Electrical Requirements in this chapter.
Ensure the power cord is not being pinched under the front of the unit.
2. Toggle the on/off (I/O) power switch under the front end of the unit to the on position (I). The
control panel will light up.
TimeandDateconrmation
The rst time the unit is turned on, it prompts the user to conrm the current Time and Date. Quick
Start, Workouts, Setup or Stop will skip this requirement but it will appear again the next time the unit
is powered up until the time and date are properly set.
1. Press the ENTER key to begin editing the time, starting with the hours (HH) and then
minutes (MM) and then AM/PM/24.
2. Press the UP or DOWN keys to select the hour.
3. Press the ENTER key to accept and begin editing the minutes.
4. Press the UP or DOWN keys to select the minutes.
5. Press the ENTER key to accept and begin editing the AM/PM/24 hour setting.
6. Press the ENTER key to accept time.
Continue this procedure for the Date.
7. Press the ENTER key after the nal setting for Day. The opening screen will now be
displayed.
Time and Date conrmation complete.
To Next Page
Loading...
Need help?
General
