Cybex 530C and 530R Owner’s Manual
Safety
Page 1-2
Facility Safety Precautions
• Make sure all user and safety precautions are observed.
• Read the Owner’s Manual carefully before assembling, servicing or using the equipment.
• Make sure that all users are properly trained on how to use the equipment.
• Make sure that each machine is set up and operated on a solid level surface. Do not install
equipment on an uneven surface.
• Make sure there is enough room for safe access and operation of the equipment.
• Perform regular maintenance checks on the equipment. Also pay close attention to all areas most
susceptible to wear, including (but not limited to) cables, pulleys, belts and grips.
• Immediately replace worn or damaged components. If unable to immediately replace worn or
damaged components then remove from service until the repair is made.
• Do not attempt repairs, electrical or mechanical. Seek qualified repair personnel when servicing. If
you live in the USA, contact Cybex Customer Service at 888-462-9239. If you live outside the USA,
contact Cybex Customer Service at 508-533-4300.
• Disconnect the optional power adapter before servicing the cycle.
• Keep a repair log of all maintenance activities.
• Use only Cybex supplied components to maintain/repair the equipment.
• Use Cybex supplied AC power adapters only.
• Do not use attachments for the cycle unless recommended by Cybex.
• Do not use the cycle if: the cycle is plugged into an optional power adapter that has a damaged
cord; (2) the cycle is not working properly or (3) if the cycle has been dropped or damaged. Seek
service from a qualified technician.
• Do not use the optional power adapter in damp or wet locations.
• Do not operate the cycle around or where aerosol (spray) or where oxygen products are being
used.
• Do not use the cycle outdoors.
NOTE: It is the sole responsibility of the user/owner or facility operator to ensure that regular
maintenance is performed.
To Next Page
Loading...
Need help?
General
