Cybex 530C and 530R Owner’s Manual
NOTE: The power adapter is optional on the Cybex 530 Cycle.
The power requirement for the optional power adapter is: 100-240 V, 50/60 Hz, 1.0A AC.
NOTE: Use Cybex supplied adapter only, NEMA 5-15 plug (TR-18231) or IEC-320 inlet (TR-18230). If
using the IEC-320 inlet adapter, ensure a proper power cord is sourced and connected
properly. Consult an electrician if you have any questions.
Setup
and Assembly
Page 5-2
! WARNING: Use extreme caution when assembling the unit. Failure to do so could result in
injury.
! WARNING: Always use proper lifting methods when moving heavy items.
Tools Required
• 3/16” Allen wrench (supplied)
• 1/4” Allen wrench (supplied)
• Phillips screwdriver
NOTE: The words “left” and “right” denote the user’s orientation.
1. Read and understand all instructions thoroughly before assembling the unit.
NOTE: Each step number in the assembly instructions tells you what you will be doing. The lettered
steps following each step number describe the procedure required. Do not continue with step 2
until you have carefully read all of the assembly instructions.
2. Verify you have received the correct package.
A. Read the sticker on the outside of the box and verify that the model number and language is
what you ordered.
3. Unpack and verify the contents of the boxes.
A. Lift up and remove the cardboard sleeve that surrounds the unit.
B. Verify that you have the color that you ordered by looking at the paint.
Electrical Power Requirements
Assembling the Cybex 530 Cycle
To Next Page
Loading...
Need help?
General
