Cybex 530C and 530R Owner’s Manual
! WARNING: Be sure that all electrical requirements are met as indicated in the specifications at
the front of the manual and at the beginning of this chapter prior to proceeding.
Use the following instructions to test the full resistance of the unit.
1. Plug the optional power cord into a power outlet from a grounded circuit as described under
Electrical Requirements in this chapter. NOTE: Coil up the remainder of the power cord and place it
out of the way. See Figure 1.
NOTE: Cybex recommends that the unit be unplugged when not in use.
NOTE: Power adapter IEC-320 (TR-18230) is not supplied with additional power cord. Additional power
cord plug varies per country. Ensure a proper power cord is sourced and connected properly.
Consult an electrician if you have any questions.
Additional power
cord for TR-18230
(not included).
Testing the Operation
Setup
and Assembly
Page 5-13
NEMA 5-15 plug
(TR-18231)
Figure 1
IEC-320 inlet
(TR-18230)
Plug varies
per country
To Next Page
Loading...
