Assembly and Setup
Page 2–13
Cybex 750C/750R Owner’s Manual
WARNING: Be sure that all electrical requirements are met as indicated in the specifications at
the front of the manual and at the beginning of this chapter prior to proceeding.
Testing the Operation
Use the following instructions to test the full resistance of the unit.
1. Plug the optional power cord into a power outlet from a grounded circuit as described under
Electrical Requirements in this chapter. NOTE: Coil up the remainder of the power cord and place it
out of the way.
NOTE: Cybex recommends that the unit be unplugged when not in use.
2. Observe that the control panel will illuminate and be in the Dormant Mode when using the optional
power adapter.
NOTE: If not using the optional power adapter, the display will not illuminate until step 4.
3. Hold the handrails to steady self while stepping into the pedals.
4. Begin pedaling.
5. Press the Quick Start key. The unit begins with a long tone.
6. Run the unit through its full resistance range. First press the Level + key until the unit reaches its
highest load (the display will show “21”). Then press the Level - key until the unit reaches its
lowest load; the display will show “1”.
7. Press Pause/End to end the workout review and return the display to Dormant Mode.
WARNING: Wait until all moving parts come to a complete stop before dismounting.
8. Wait until pedals come to a complete stop before dismounting the unit. Hold the handrails to
steady self while stepping off the unit.
To Next Page
Loading...
Need help?
General
