Operation
Page 3–12
Cybex 750C/750R Owner’s Manual
Fan Control
The fan defaults at the “OFF” setting. The user can change to “LO” or “HI” setting by pressing the
appropriate control key. NOTE: User must be pedalling for fan to operate.
Alarm Set
To set up an alarm to sound during workout:
1. Press key #8 on the keypad, also labeled with an alarm clock icon. Text Area will display
“ALARM AT HH:MM Y”. Initially, this display refl ects actual time.
2. Use keypad to enter a direct time. Press the ENTER key after each entry to accept and move
forward.
HH (Hour) MM (Minutes) Y=A (AM) or P (PM)
NOTE: The LEVEL key is also active to adjust the display value (up or down). Hold down key to
accelerate rate of increment.
Once alarm time occurs, the display will show “ALARM” and start beeping. Press the CLEAR, ENTER or
ALARM key to reset.
Battery Sentry
Battery Sentry uses display feedback (speed signal, key presses and heart rate) to determine user
presence. If a user is not detected within 20 seconds, the display beeps and inquires
“ARE YOU THERE?”.
Resume pedalling, grab the contact heart rate grips or press any key within a pre-selected time to resume
workout.
To Next Page
Loading...
Need help?
General
